Mailing List Archive

Mailing List: techdiver

Banner Advert

Message Display

Date: Sun, 15 Apr 2001 15:17:47 +1000
To: <RDecker388@ao*.co*>, rikard.lundgren@sw*.se*
From: Bruce Stewart <bruces@sh*.ne*.au*>
Subject: Re: Isolating Manifold Question
Cc: techdiver@aquanaut.com
Bob,

The Iso valve is there for what its describes "Isolation", theres no
point in having it fully open as it acheives nothing. If you need to
isolate a cylinder and are losing gas then the quicker the better.
Remember when this happens every ounce counts. It can be confusing
only because the loss of gas is still happening from the failed system
half. The failed side should still be breathed till exhausted if one can.
Then hop onto what should be 50% of what you had when the failure
occured. The iso should be just cracked open to allow equalisation and shut
with the minimum of effort, come on think about this and get your head out 
of the rubbish the agencies print. It is not common sense to have the iso valve
fully open. Common sense is being familiar with the on/off directions of
all valves
and your buddies valves as well.

Bruce

At 07:55 PM 4/14/01 -0400, RDecker388@ao*.co* wrote:
>In a message dated 4/14/01 9:55:22 AM Eastern Daylight Time, 
>rikard.lundgren@sw*.se* writes:
>
>> >As for the 3/4 of European divers using this method, divers taking there 
>> first steps into tech training , do so with IANTD or TDI,
>>    >, as shut downs are apart of syllabus, my instructor  & people i have 
>> listened to use this method, and as far as i a aware As the said 
>> organisations are wide spread >around Europe , i can only conclude that 
>they 
>> are also shown this method.
>>  
>
>
>I suspect this is more a matter of the individual instructor than what's 
>actually in the standards.  I've read both of these agency's standards at one 
>time or another and do not recall a single line about requiring paritially 
>open ISOs.
>
>Common sense dictates that all valves need to be either all the way on or all 
>the way off.  In a stressful situation requiring a valve shut-down it would 
>be way too easy to turn the valve the wrong way if it's only partly open.  
>With a strict on/off approach, the valve is only going to turn one way...... 
>THE RIGHT ONE!  Bare handed, gloves or mitts, shutting down a valve is not a 
>difficult matter with a little practice.
>
>Bob D. 
>www.SportDiverHQ.com
>--
>Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
>Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.

--
Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]