shim "kit" - manhatten supply -comes with the tools -----Original Message----- From: Bob s <szczepanski@te*.co*> To: trey@ne*.co* <trey@ne*.co*> Cc: techdiver@aquanaut.com <techdiver@aquanaut.com> Date: Tuesday, May 09, 2000 6:20 PM Subject: Re: burst disks >I never have had much luck with making the shim fit. How do you cut the >shims consistently? I asked about LP plugs because >I actually have some plugs that have a hex head on them, off an old dacor >reg., I think. These look exactly like >the burst disk plug, just no hole. unless you look very close you would >think it the plug is a burst type. > >bob s >Some days it is just not worth gnawing through the restraints. > > > >----- Original Message ----- >From: "Trey" <trey@ne*.co*> >To: "Bob s" <szczepanski@te*.co*> >Cc: <techdiver@aquanaut.com> >Sent: Monday, May 08, 2000 12:15 PM >Subject: Re: burst disks > > >> The metal is too hard - you still need to put a disk under it to make it >> seal, and that corrodes and it leaks. Just buy a shim kit and make some >> 1/16" disks. >> >> Bob s wrote: >> > >> > has anyone tried replacing the burst disk with the regulator LP port >> > plugs? the threads appear to be same. the LP plug does screw in. if I >> > use the nylon washer from the burst disk, will this plug work? >> > >> > bob s >> > Some days it is just not worth gnawing through the restraints. >> > >> > >> > >> >> -- >> Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. >> Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'. >> >> > > -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]