I told you , get a shim KIT - comes with the tools , the punches, etc. Bob s wrote: > > I never have had much luck with making the shim fit. How do you cut the > shims consistently? I asked about LP plugs because > I actually have some plugs that have a hex head on them, off an old dacor > reg., I think. These look exactly like > the burst disk plug, just no hole. unless you look very close you would > think it the plug is a burst type. > > bob s > Some days it is just not worth gnawing through the restraints. > > ----- Original Message ----- > From: "Trey" <trey@ne*.co*> > To: "Bob s" <szczepanski@te*.co*> > Cc: <techdiver@aquanaut.com> > Sent: Monday, May 08, 2000 12:15 PM > Subject: Re: burst disks > > > The metal is too hard - you still need to put a disk under it to make it > > seal, and that corrodes and it leaks. Just buy a shim kit and make some > > 1/16" disks. > > > > Bob s wrote: > > > > > > has anyone tried replacing the burst disk with the regulator LP port > > > plugs? the threads appear to be same. the LP plug does screw in. if I > > > use the nylon washer from the burst disk, will this plug work? > > > > > > bob s > > > Some days it is just not worth gnawing through the restraints. > > > > > > > > > > > > > -- > > Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. > > Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'. > > > > > > -- > Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. > Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'. -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]