Mailing List Archive

Mailing List: techdiver

Banner Advert

Message Display

From: "Bob s" <szczepanski@te*.co*>
To: <trey@ne*.co*>
Cc: <techdiver@aquanaut.com>
Subject: Re: burst disks
Date: Tue, 9 May 2000 17:17:44 -0500
I never have had much luck with making the shim fit. How do you cut the
shims consistently? I asked about LP plugs because
I actually have some plugs that have a hex head on them, off an old dacor
reg., I think. These look exactly like
the burst disk plug, just no hole. unless you look very close you would
think it the plug is a burst type.

bob s
Some days it is just not worth gnawing through the restraints.



----- Original Message -----
From: "Trey" <trey@ne*.co*>
To: "Bob s" <szczepanski@te*.co*>
Cc: <techdiver@aquanaut.com>
Sent: Monday, May 08, 2000 12:15 PM
Subject: Re: burst disks


> The metal is too hard - you still need to put a disk under it to make it
> seal, and that corrodes and it leaks. Just buy a shim kit and make some
> 1/16" disks.
>
> Bob s wrote:
> >
> > has anyone tried replacing the burst disk with the regulator LP port
> > plugs? the threads appear to be same. the LP plug does screw in. if I
> > use the nylon washer from the burst disk, will this plug work?
> >
> > bob s
> > Some days it is just not worth gnawing through the restraints.
> >
> >
> >
>
> --
> Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
> Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
>
>

--
Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]