Manos, Make sure the backplate is not binding against the tanks and trapping the harness.You may have to add a few stainless nuts to the lower tank band bolt to shim out the plate. It would also help to grind/radius the edges of the slots that the waist strap portion of the harness passes through.This will allow the harness to slide easily and provide a little more slack in the shoulder straps. It is also easier if you can flip the entire rig over your head as you "duck" into the water. Later, ----- Original Message ----- From: Manos Manoli <manos@ma*.co*.cy*> To: Tech Diver <techdiver@aquanaut.com> Sent: Friday, January 21, 2000 2:32 AM Subject: Hard to get out > I have just finish the Diving tests on my new Hardplate it works fine. > My only serious problem is ( try not to laugh ) that on the surface i > cannot get out of it. The inflated wings push slightly against my body > so the harness gets tight on me. I know is not DIR to install plastic > joins but i was thinking of installing only one at the side. Any ideas? > > Manos. > -- > Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. > Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'. > > > -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]