Mailing List Archive

Mailing List: techdiver

Banner Advert

Message Display

From: "Sean T. Stevenson" <ststev@un*.co*>
To: "Jbdvr@ao*.co*" <Jbdvr@ao*.co*>,
     "techdiver@aquanaut.com"
Date: Wed, 03 Nov 1999 08:27:22 -0800
Subject: Re: gear rigging question
Keep your SPG where it is, but use a weak link attachment to the bolt
snap.  I bend an o-ring around the snap, and then thread the HP hose
through this.  This permits me to grab the gauge to read (if I can not
see it merely by looking down, the o-ring slides up the HP hose), and
then restow by sliding the bolt snap back down.  Use an o-ring that is
strong enough to be able to slide along the hose without breaking, but
weak enough that you can break it by pulling when you need to.

-Sean


On Tue, 2 Nov 1999 22:18:21 EST, Jbdvr@ao*.co* wrote:

>LIST, when diving cave-just got my full-cave- i dive DIR with the SPG clipped 
>off on the left waist strap D-ring, and view it by unclipping and reclipping 
>which works fine. deco bottles are genearly not a problem because they are 
>left at the cave entrance or close to it. but i noticed when one is doing a 
>deep wreck and carries a deco bottle on the left side with  the light 
>cannister on the right side, it is almost impossible to unclip and view the 
>SPG for the back gas. this could pose a problem. Any good solutions for 
>managing a deco bottle and pressure gauge on the same side? should it go 
>accross the chest ?   thanks in advance......joe boone
>--
>Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
>Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
>


--
Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]