Mailing List Archive Mailing List Archive
You bet - I've done this before, but here goes: Right Post: Angle reg "sideways" so that the two-port side of the reg is pointing directly down. Put the long hose on the outboard most port, and the bc inflator on the inboard most port. Left post: Angle reg sidways so that the three-port side of the reg is down. Put the hp hose on the hp port, the short hose on the inboard most port, and the drysuit inflator (if used) on the outboard most port Short hose crosses under everything else on the right post, long hose points directly down, bc inflator crosses back over to the bc, etc etc etc. At 06:51 PM 4/11/1999 -0700, you wrote: > >Would anyone care to share some rigging tips for the APEKS Tech - DS4. > >Thanks >Mike Williams > >-- >Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. >Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'. > ----------------------------------------------- Kevin Connell <kevin@nw*.co*> NW Labor Systems, Inc http://www.nwls.com And I suppose you want a user interface with that..... ----------------------------------------------- -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]