Mailing List Archive

Mailing List: techdiver

Banner Advert

Message Display

From: <CHKBOONE@ao*.co*>
Date: Tue, 7 Oct 1997 08:31:58 -0400 (EDT)
To: techdiver@aquanaut.com
Subject: Re: ZIP TIES
In a message dated 97-10-07 06:40:34 EDT, you write:



<< Could someone please enlighten those of us that are not as well
trained 
 as perhaps we should be. What would you use in lieu of a zip tie and 
 where can it be obtained? 
 And what kind of a knot would you use to attach a snap hook to a light or 
 other piece of equipment.?
 
 Cheers
 
 Tony - >>


A couple of suggestions :

IF you must use these zip ties (also called ty wraps)  use them in pairs and
arrange for one to be older than the other so that it will break as an
indicator that the other is soon to follow.  (if you put two new ones on at
the same time just change one a couple of months later).   I don't think they
actually rot I think they probably weaken form cold flow of the plastic under
pressure.    Some have a steel burr, others have plastic.  I don't know which
is best for sure.  

An alternative to these for some applications, if you don't like line and
knots, is the stainless steel split rings used in sailboat fittings.   These
are just like key ring split rings except that some disigns bring one free
end of the ring to the inside to make instalation onto the pins they lock
into place easier.   Bend this part out so it is alongside the rest of the
ring like a normal split ring and, if you like, run a piece of tight fitting
plastic tube onto the ring (just like you would a key) to cover the sharp
ends of the wire once you have it installed on the item (actually shrink
tubbing is easier to do this with - Radio Shack).  

Keep in mind that these can not be cut away if necessary so be mindful of
where you are using them.  

This provides a removable ring that you can attach clips to but will not take
the place of mouthpiece and hose retainers, of course.   For this I just use
the selectively aged ty wraps and "glue".

I have found shoo goo and Stick n Seal by Locktite to be great for holding
knots together and for holding mouthpieces and hoses in place in conjunction
with ty wraps.   These adhesives will give you some reliable leway if you
check your ty wraps regularly.   They both dry fast and are tough as nails -
Clean the area good and make sure they are cured before using.

Chuck





--
Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]