Mailing List Archive

Mailing List: techdiver

Message Display

 This is bullshit - hammer the thing smooth, fill it with solder, and tripple 
the disk, or just plug it. I like all six empty when playing Russian Roulette, 
but I see some of like to have at least a few in the chambers. Good luck


On Tue, 7 Jan 1997, <CHKBOONE@ao*.co*> wrote:
>I have seen some disks cut and dented unevenly by the poorly machined edge of
>brand new plugs.   The disk normally bulges slightly into the hole in the
>plug when installed and if rough edges are cutting into the disk it blows the
>rating and reliability all to hell.   I use "no pops" in all important
>supplys and every tech diver should inspect the plug itself for clean edges
>where it meets the disk. 
>
>Chuck
>--
>Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
>Send subscription/archive requests to `techdiver-request@aquanaut.com'.
>
>


George M. Irvine III
DIR WKPP
Woodville Karst Plain Project
1400 SE 11 ST Ft Lauderdale, FL 33316
954-493-6655 FAX 6698
Email gmiiii@in*.co*

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]