Mailing List Archive

Mailing List: techdiver

Message Display

>John,
>
>Just disassembled my brand new Seapro wings.  The thinner of the two
washers is 
>between the shell and the screw-on fitting, that is, it is the first thing
on the 
>outside of the cordura shell.  Next is the screw-on fitting.  Then, the
thicker 
>rubber washer, and the inflator.  The thicker washer goes between the fitting 
>that screws onto the bladder (on the outside of the shell) and the inflator.
>
>Hope this helps.

Thanks, Dave.  That does help; it confirms a hunch.

It turns out that the problem was that Seapro had installed two (2) of the
thin washers where there should only have been one.  This was preventing a
proper seal somewhere in the assembly.

Again, thanks.
--John

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]