Mailing List Archive Mailing List Archive
John, Just disassembled my brand new Seapro wings. The thinner of the two washers is between the shell and the screw-on fitting, that is, it is the first thing on the outside of the cordura shell. Next is the screw-on fitting. Then, the thicker rubber washer, and the inflator. The thicker washer goes between the fitting that screws onto the bladder (on the outside of the shell) and the inflator. Hope this helps. john.r.strohm@BI*.co* wrote: > > One of y'all is bound to know the answer to this one, before I call Seapro. > > The Seapro wings inflator with the pull dump uses a screw-on fitting at the > bladder. My inflator popped off today, apparently it had come unscrewed > and I hadn't noticed it. (I've never seen screw-on inflators before, just > hose clamps.) Luckily, it happened on land, and not in the pool; I > recovered the two washers. Therein lies my question. > > There is the plastic bladder. There is the nylon bladder shell. There is > a threaded fitting permanently attached to the bladder. There are these > two large thin rubber washers, and there is the inflator assembly. Am I > correct in believing that the washers are intended to sandwich the bladder > shell? > > Spare me the comments about the pull dump, please. I didn't order it that way. > > Thanks. > --John > -- > Send mail for the `techdiver' mailing list to `techdiver@terra.net'. > Send subscription/archive requests to `techdiver-request@terra.net'. -- <<<<<<======------======>>>>>> Dave Mabry dmabry@mi*.co* Great Lakes Maritime Institute Underwater Research Team <<<<<<======------======>>>>>>
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]