Mailing List Archive Mailing List Archive
Gil wrote: >So, I have a 300 bar DIN 1st stage with >a low pressure valve. Apparently there is no problems with the threads... >well... >PS: That yoke was working fine ! Gil, I, too have a question on this: my Dive-Rite Benjamin valve (manifold) on my hp80's is, I believe, a 300bar valve system; my Poseidons' male DIN connectors, which are stamped "300 bar", bottom out in the sockets with no threads showing. On the other hand, the Sherwood DIN adapter I have on my third reg (Dacor) will bottom in these sockets with lots of threads showing (works fine, just hideous). I was assuming that the Sherwood adapter just had extra thread length, since the Odin "300 bar" fittings bottom in the valves. My question is, how deep, in inches, mm, cm, or whatever, is a 300bar vs. a 200bar socket? If I in fact have a 200bar manifold, are Poseidon 300bar male fittings shorter than what we Americans call "300 bar fittings"? Thanks, flames to private mail ABRILL IANTD 6791 NOAA Working Diver PADI DMC ____"Fool! I am the Fates' lieutenant; I act under orders!" - Ahab___ Andrew L. Brill *abrill@ro*.ge*.du*.ed* Duke University Department of Geology * FAX (919) 681-8228 Prog. for the Study of Developed Shorelines* Durham, NC 27708-0228 *
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]