Mailing List Archive Mailing List Archive
Imagine how a thread cutting die is held in the handle. You can easyly make a brass sleeve with a closely fitting bore, and to grip the reg use radial allen head screws with cylindrical ends. Matthias > "KAMARUDIN, Stephen" schrieb: > > Greetings List > I am about to re-tune a couple of Apeks DS4's - the factory set IP is > too high at just under 11 bar. > To get to the spring adjuster on the low pressure side I have to > remove an environmental sealed cover/diaphragm and need to use a pin > spanner. Some people call these hook spanners or hook wrenches. There > is a picture of one of these spanners at an excellent DIR site > > http://www.deeperstuff.com/apeks-1st.htm > I was wondering if anyone know where I can get a couple of these pin > spanner/wrenches? Is there a name/brand for this tool? Where should I > look? > > The only spanner I can find like it is an "adjustable" pin spanner by > "Snap-on" and they (the retailer) wanted about US$65 for it. This > seemed a bit steep. I suppose I could make one but wanted to seek > advice first. > > thanks in advance > > Stephen Kamarudin > Perth, Western Australia -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]