Manos, I also had this problem after removing QRs and running a continuous harness and was really frustrated. The trick is loosening the shoulder straps a bit (the problem being we all seem to make them too tight at the beginning as we unfortunately get used to the QRs on commercial harnesses or BCs) -- and not overinflating your wing on the surface. As I'm relatively thin, I found the best way that worked for me was to sit in the harness on surface, make sure the shoulder straps could "just about" slip over the shoulder (right at the shoulder area) and pull them in by an inch. Make sure your hand, bent back, can slide in and push the strap off the harness on one side. It worked fine for me and inwater practice made perfect. As I've now got used to it, in my new harness I've tightened the straps to a more comfortable position. I would suggest practicing this before turning to "alternatives." It is really comfortable, safe and sound. Regards Izzy ----- Original Message ----- From: Manos Manoli <manos@ma*.co*.cy*> To: Tech Diver <techdiver@aquanaut.com> Sent: Friday, January 21, 2000 10:32 AM Subject: Hard to get out > I have just finish the Diving tests on my new Hardplate it works fine. > My only serious problem is ( try not to laugh ) that on the surface i > cannot get out of it. The inflated wings push slightly against my body > so the harness gets tight on me. I know is not DIR to install plastic > joins but i was thinking of installing only one at the side. Any ideas? > > Manos. > -- > Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. > Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'. -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]