Pete, besides there being all kinds of brass ( like steel ) with some
having bullshit coatings or internal parts and sticking, and most being
too short-shanked to operate properly ( you have solved that problem),
the other big reason we do not use them is that they are softer and tend
to become jammed if bumped against something, as in two bottles hitting
each other, or in handing of the tanks on land or boat. They also tend
to have sharp edges in the thumbslide and cut wet fingers.

In general, I like gear that I can use for all diving with no
mondifications. Since it does no harm to have oversized bolt snaps on
the gear for warm water, I leave the big ones on for the rare times that
I may use gloves just out of principle. In reality, if I need gloves, I
am lobster diving or have taken leave of my senses.

Peter Fjelsten wrote:
> 
> Den 17:10 04-07-99  skrev Jim Cobb:
> >George the MC ones are slightly magnetic, and there are some rust stains
> >around the snap. Like I said I have not experienced a failure so far, but
> >then I do rinse them off after a dive and lube them regularly. All all my
> >diving is in salt water so I have to take extra precautions against
> >corrosion problems.
> 
> I dive in salt water exclusively and I have found the brass bolt snaps to
> be very good if you just spray the spring with some WD-40. After this it
> does not rust. Reapply after 50-100 dives. I have had problems finding S/S
> bolt snaps and as long the brass ones work I don't see any reason for
> changing them.
> 
> ://Peter Fjelsten


--
Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'.
Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]