Mailing List Archive Mailing List Archive
Frank Thanks for the explanation, I had a similar one from John Brett - you are spot on with the analysis and your prediction of the UK calibration reading in SA is also correct. I noticed this on other O2 meters in Badgat (900m) and put it down to them being old sensors, rather than the altitude affecting them. Thanks again for the information. David Shimell Project Manager, Sequent Computer Systems Ltd., Sandton, South Africa. Email: shimell@se*.co* <mailto:shimell@se*.co*> -----Original Message----- From: Frank Riffel [SMTP:frank.riffel@en*.co*] Sent: Friday, May 14, 1999 12:00 PM To: Shimell, David (shimell) Cc: techdiver@aquanaut.com Subject: Re: O2 Sensor Calibration "Shimell, David (shimell)" wrote: > All > > I recently travelled from the UK to South Africa bringing over my O2 Analyser > - a Vandergraph with Teledyne O2 sensor. On arriving home in Johannesburg I > started playing with my equipment. (as one does). I noticed that I had to > adjust the calibration dial to about the 2 O'clock position whereas > previously it would calibrate at the 12 O'clock position. Any ideas as to > why? > > I was at around sea level in the UK, and Johannesburg is at about 1500m I > think. The equipment was carried as hand luggage on the plane and the 2 > O'clock calibration was repeated and verified 24 hours later. > > I wondered whether the quantity of O2 was lower at altitude but someone I > spoke to said this was insufficient to make a difference. I can only think > that the ambient pressure is the reason but cannot understand why. > Alternatively, the galvanic cell could have been affected by the flight. > Just curious. The usual galvanic cells do not measure the O2 percentage they meassure the partial pressure of the oxygen. When you travel to altitude the ambient pressure and therefore the ppO2 of the air drops. At this altitude one might expect a ppO2 of 0.850bar*21% = 0.178 bar. That means your analyzer should read about 17.8 % on the 12o'clock position. Regards, Frank -- Send mail for the `techdiver' mailing list to `techdiver@aquanaut.com'. Send subscribe/unsubscribe requests to `techdiver-request@aquanaut.com'.
Navigate by Author:
[Previous]
[Next]
[Author Search Index]
Navigate by Subject:
[Previous]
[Next]
[Subject Search Index]
[Send Reply] [Send Message with New Topic]
[Search Selection] [Mailing List Home] [Home]