Mailing List Archive

Mailing List: cavers

Banner Advert

Message Display

From: <houdini@gr*.xt*.ne*>
Date: Mon, 03 Apr 2000 14:14:15 -0400
To: polarbea@sa*.ne*
CC: cavers@cavers.com, techdiver@aq*.co*
Subject: Re: Service question re Scubapro MK10 1sts
joe wrote:
> 
> Anyone know the proscribed method for removing the HP seats from MK10
> 1st stages when using new kits that use no shims but come with three
> different size seats?  With the older kits the seats would blow out
> using compressed air on the pin hole from behind but for some reason
> these newer ones will not budge.  The first time I ran into this I
> thought it was a bad seat and removed it using a puller that I had to
> screw into the face of the seat.  This has the potential to do damage so
> hopefully, someone knows a better way.
> 
> Thanks.
> 
> Joe Citelli
Hi Joe,
	The best way I have found, on other brands of regs: There is usually a
very small hole that runs into the back of the seat. A small drill bit
will usually push the seat out nicely for me. Good
luck.              													Norm

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]