Mailing List Archive

Mailing List: cavers

Banner Advert

Message Display

Date: Sun, 02 Apr 2000 20:24:46 -0500
To: Dvrcraig@ao*.co*, polarbea@sa*.ne*, cavers@cavers.com
From: Scott Hunsucker <swhac@pc*.gu*.ne*>
Subject: Re: Service question re Scubapro MK10 1sts
Cc: techdiver@aq*.co*
The easiest way of removing them for us is to take a wood screw and screw 
it into the seat by hand at a slight angle.  The screw will push against 
the bottom of the cap and the seat will pop out.  Takes all of about 5 seconds.
Scott
At 08:54 PM 04/02/2000 -0400, Dvrcraig@ao*.co* wrote:
>Iv'e had the same trouble with Mk 10 and Mk 15 seats getting stuck. I use a
>small bore drill bit or a hobby tool to CAREFULLY drill a hole diagonally
>into the seat, and then use a drill blank, or awl to lever the offending
>piece of high tech plastic out. This might be drastic, but it works. Any
>suggestions welcomed.
>
>                                            Craig

Navigate by Author: [Previous] [Next] [Author Search Index]
Navigate by Subject: [Previous] [Next] [Subject Search Index]

[Send Reply] [Send Message with New Topic]

[Search Selection] [Mailing List Home] [Home]